TSP 550 - structure spray - 400ml
TSP 550
The go-to solution for repairing textures on plastic parts. With a variety of structural finishes to choose from, this product is user-friendly, ensuring a seamless application. The quick-drying formula allows for efficient repairs, and it can be easily painted over with any conventional 1K basecoat and 2K topcoat systems.
Key features
-
- • Special product to repair the texture on plastic parts
-
- • Choice of structural finishes
-
- • Easy to use
-
- • Dries very quickly
-
- • Can be painted over with all conventional 1K basecoat and 2K topcoat systems
Product details
- Colour
- black
- Dry storage
- yes
- Freezing resistant
- yes
- Material
- plastic plastic
- Maximum storing temperature
- 25 °C
- Number
- TSP 550
- 1K product
- yes
- 2K product
- no
- Anti-corrosion
- no
- Base ingredient(s)
- acrylic resin talcum
- Coverage
- 3 m²/L
- Dry layer film thickness
- 120 µm
- Gloss level
- 0 %
- Lead-free
- yes
- Particle size
- 35 µm
- Pressure
- 3.8 bar
- Propellant
- dimethyl ether
- Recommended number of layers
- 1-2
- Solid content
- 25.4 g/ml
- Solvents
- yes
- Type
- aerosol
- VOC
- 622 g/L
- Volume
- 0.4 L
- Workable surface state
- dry
- Sales unit
- 1
- Units for outer box
- 12
- Units for pallet
- 672
- Minimum Order Quantity
- 12
Application
-
Application TSP 550 - Directions for use:
- Surface Preparation: Clean the area thoroughly to remove oils, waxes, and other contaminants. Light sanding is recommended for best adhesion.
- Shake Well: Shake the can vigorously for at least 2 minutes after the mixing ball starts rattling.
- Test Spray: Apply a test patch on a hidden area to check for desired texture and finish.
- Application: Hold the can approximately 20cm – 30cm (8-12 inches) from the surface and apply using a steady, sweeping motion.
- Layering: For heavier textures, apply additional coats as needed.
- Drying Time: Allow at least 10-15 minutes between coats, and a minimum of 24 hours for full cure.
- Nozzle Maintenance: Invert the can and spray for 2-3 seconds to clear the nozzle.