TSP 140 - Primer white 400ml
TSP 140
This versatile primer/filler is suitable for finishing with all solvent and water-based 1K and 2K paints. Perfect for a variety of surfaces, it's ideal for fast repairs after sanding too hard, spot or panel repairs, and smaller surfaces. Apply fine layers for optimal results. The primer/filler sprays feature a special nozzle, providing a flat vertical pattern akin to a spray gun. Shake the can thoroughly before the first use for the best performance.
Key features
-
- • Universal primer/filler in white, light grey, grey and dark grey suitable to finish with all solvent and water based 1K and 2K paints.
-
- • Can be applied on all surfaces, ideal for fast repairs after sanding too hard. Also ideal for spot or panel repair, especially for smaller surfaces.
-
- • Apply fine layers. If you desire a thick layer: first apply 1 full layer at a distance of 30-35cm and afterwards finish with a crosswise layer at a distance of 20cm.
-
- • All primer/fillers sprays have a special nozzle which sprays a flat vertical pattern, comparable to a spray gun.
-
- • Primer with a high viscosity: shake the can very well before the first use.
Product details
- Colour
- white
- Dry storage
- yes
- Freezing resistant
- yes
- Number
- TSP 140
- Storing condition
- dark
- Base ingredient(s)
- acrylic resin zinc phosphate talcum
- Particle size
- 40 µm
- Pressure
- 3.6 bar
- Propellant
- dimethyl ether
- Solid content
- 21.7 g/ml
- Solvents
- yes
- Type
- aerosol
- VOC
- 647 g/L
- Volume
- 0.4 L
- Workable surface state
- dry
- Sales unit
- 1
- Units for outer box
- 12
- Units for pallet
- 672
- Minimum Order Quantity
- 12
Application
-
TSP 110 – 120 – 130 – 140 application - Directions for use
- Clean Surface: Remove any loose paint, rust, or dirt. Surface must be dry and free from oil or grease.
- Shake Well: Shake the can vigorously for at least 2 minutes after the mixing ball starts rattling.
- Test Spray: Perform a test spray on a hidden area to ensure compatibility and color match.
- Apply Primer: Hold the can 20cm – 30cm (8-12 inches) from the surface and apply 2-3 light coats, allowing 5-10 minutes of drying time between each coat.
- Dry: Allow at least one hour before applying the topcoat or additional primer for higher build.
- Nozzle Maintenance: Clear the nozzle by inverting the can and spraying for a few seconds.